LPD8806
Moderators: adafruit_support_bill, adafruit

LPD8806

by sandar on Tue Mar 19, 2013 4:12 pm

I've been programming the LPD8806 using the LEDBeltKit as my base and just modifying the code. I'm not sure why but the first pixel of my string is always on green. When it's supposed to change colour the green light stays on full and the red and blue turn on as they're supposed to. I tried putting the original LEDBeltKit code on again but the green light still stays on. I thought it was the code but could it be the hardware? Any suggestions to fix? All the other lights seem fine, just the first light.
sandar
 
Posts: 1
Joined: Fri Mar 08, 2013 7:14 pm

Re: LPD8806

by adafruit_support_bill on Fri Mar 22, 2013 6:53 am

It is not unusual for there to be a bit of green flicker on the first pixel as you are writing to the strip, but it shouldn't be full-on. Sounds like your strip has a bad pixel. If you contact support@adafruit.com with a link to this thread they can send out a replacement for you.
User avatar
adafruit_support_bill
 
Posts: 30674
Joined: Sat Feb 07, 2009 10:11 am