Low-Profile MicroSD Adapter flattening pins?
Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

Low-Profile MicroSD Adapter flattening pins?

by nmalinoski on Thu Feb 28, 2013 1:32 pm

I was originally considering picking up one of these low-profile adapters, but I read somewhere (I wish I could remember where) that someone who had used one had difficulty using other SD cards after using the low-profile adapter because it had flattened the pins in the SD card receptacle. Looking at the high-res photos of the bottom of the adapter (As well as that similar transverse-slot adapter from that run on Kickstarter), I can sort of understand why: a normal SD card/shim has recessed contacts, whereas these low-profile adapters do not--they are completely flat on the bottom.

That said, I'm still interested in getting one of these adapters, but that story leaves me curious; has anyone experienced flattened pins with either of these adapters?
Posts: 6
Joined: Wed Jan 16, 2013 11:47 am