B+ cobbler

Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Locked
User avatar
egutting
 
Posts: 297
Joined: Wed Nov 14, 2012 12:57 am

B+ cobbler

Post by egutting »

I purchased one from a reseller yesterday......I tried pulling the cable off the pi and out of the cobbler and the cable has fallen apart. The cap at the ends has broken off and the cable has came out of the slots. Anyone else experiencing this?
Top
User avatar
adafruit_support_rick
 
Posts: 35092
Joined: Tue Mar 15, 2011 11:42 am

Re: B+ cobbler

Post by adafruit_support_rick »

Please email [email protected] with a link to this thread for a replacement cable.
Top
User avatar
egutting
 
Posts: 297
Joined: Wed Nov 14, 2012 12:57 am

Re: B+ cobbler

Post by egutting »

It's ok for now as I was able to super glue it back together :) This is just a testing setup for the B+ (As I normally use B) so I'm not too concerned about it at this time, just wanted to know if anyone else was experiencing the issue. It seems that it's a pretty tight fit and its very difficult to get off.
Top
Locked
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/

Return to “Adafruit Raspberry Pi® accessories”