Hi guys.
i've checked the VCO in the scope, ive found that it have a massive offset.
take a look at the ground reference (the line below in the screen):
now, take a look in where the VCO on the screen:
is there a way to trim the offset?
or maybe the offset become more or less stable after going through the vca?
i havent checked that yet.
what do you think?
x0xb0x VCO offset, general Q
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- isak
- Posts: 835
- Joined: Wed May 27, 2009 3:54 pm
Re: x0xb0x VCO offset, general Q
ok, after going through the main output i see the offset is set as it should.
so, forget about it.
cheers,
Isak E.
so, forget about it.
cheers,
Isak E.
Please be positive and constructive with your questions and comments.