Memorial day is 05/25/2015 – Orders will ship out on May 26th. There will not be any deliveries or shipping on Monday. Any order placed after 11am ET on Friday May 22nd will not start to ship out until Tuesday May 26th.

I2C/SPI Quad Decoder
Moderators: adafruit_support_bill, adafruit

I2C/SPI Quad Decoder

by 020110348 on Fri Feb 08, 2013 8:43 am

Hi Everyone,
Im looking to upgrade my current CNC Setup. it currently has 2 250ppr encoders, I would like to be able to interface those directly to either a Raspberry Pi or Arduino Due. even just decoding the encoder one arduino (mega 1280) has a hard time keeping up.

The End-Goal: Have either one or two chips that i can request the current position from. E.x. command the controller to spin motor -> read from chip -> compare reading to desired -> adjust motor.

In summery i am looking for a chip that can decode a 5v Quadrature Encoder. AND Speek 3.3v I2C/SPI. to take the load off the controller.
020110348
 
Posts: 4
Joined: Mon Apr 23, 2012 8:22 pm

Re: I2C/SPI Quad Decoder

by zener on Fri Feb 08, 2013 2:17 pm

http://www.avagotech.com/pages/en/motio ... ecoder_ic/

The last 2 in the list seem to be the most common, but you will have to look at the data sheets to see which will be best for you.

zener
 
Posts: 2880
Joined: Sat Feb 21, 2009 2:38 am