Plastic Valve 997 Duty Cycle
Moderators: adafruit_support_bill, adafruit

Plastic Valve 997 Duty Cycle

by hawk_08 on Wed Mar 13, 2013 11:14 am

Hello everyone,

I recently buy the 12V plastic valve ( and the information on the current was quite helpful, but I was wondering does anyone has any idea of the Duty cycle? I am building an automatic valve to fill up a tank. To set my limit I wanted to know how long can I leave the valve open withouth destroying it?


Posts: 3
Joined: Fri Dec 14, 2012 2:47 am

Re: Plastic Valve 997 Duty Cycle

by adafruit_support_bill on Wed Mar 13, 2013 2:42 pm

I will check to see if there are more technical specs available. Typically with solenoid valves, the actuation current is quite a bit higher than the holding current. If you back-off on the holding current (via PWM), you can reduce coil heating considerably. Coil temperature is usually the limiting factor in duty-cycle ratings.

We do not have a duty cycle spec on these. All the data we have from the manufacturer is posted on the product description page.
User avatar
Posts: 31820
Joined: Sat Feb 07, 2009 10:11 am