Is there a way to stop this? I don't really want the fish fed at every reboot of my chip or hiccup on the power line Is it a pullup or down resistor somewhere ? I don't want fat fish
Tim
motors run on repower with L293D and Atmeg328P ?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- timwjkl
- Posts: 56
- Joined: Wed Jul 03, 2013 2:48 pm
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: motors run on repower with L293D and Atmeg328P ?
A pulldown on the Enable pins should help (pins 1 and 9). http://www.adafruit.com/datasheets/l293d.pdf
- timwjkl
- Posts: 56
- Joined: Wed Jul 03, 2013 2:48 pm
Re: motors run on repower with L293D and Atmeg328P ?
10 K resistor from the enable pins to ground correct ? If that sounds good i will try that after work tonight.
Thanks
Tim
Thanks
Tim
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: motors run on repower with L293D and Atmeg328P ?
That should do it.10 K resistor from the enable pins to ground correct ?
- timwjkl
- Posts: 56
- Joined: Wed Jul 03, 2013 2:48 pm
Re: motors run on repower with L293D and Atmeg328P ?
Thanks that works great now when it boots no pumps or feeding. The 10 K resistor on pins 1 and 9 on the L293D is perfect.
Thank You
Tim
Thank You
Tim
- adafruit_support_bill
- Posts: 88093
- Joined: Sat Feb 07, 2009 10:11 am
Re: motors run on repower with L293D and Atmeg328P ?
The fish will be disappointed. No more free snacks
- timwjkl
- Posts: 56
- Joined: Wed Jul 03, 2013 2:48 pm
Re: motors run on repower with L293D and Atmeg328P ?
Well this means I can cancel the personal trainers. The angles will be singing in the shallows and the corrys will be dancing in the weeds.
Please be positive and constructive with your questions and comments.