I am testing the TFT Touch ( Breakout option, not the shield ) with an Arduino Mega 2560, using the tutorial and code provided on the Touch's product page.https://www.adafruit.com/products/335
When running the graphics test code, I get "Unknown driver chip 1313" in the serial window... so I am guessing my wiring is wrong. Which leads me to my question:
Ultimately, the touch will be mounted inside a plastic case such that just the screen is displayed through a cut out. I thought about soldering the breakaway header pins to the board and plugging that into my breadboard for testing/prototyping, but then I am stuck with those pins for the final project ( unless I desolder them ).
So my question is: what is the easiest way to wire this guy so I can switch from prototyping to final without a bunch of re-work?
thanks in advance for the suggestions!