Hiring for circuit designs

[jdoscher]

I need a couple "basic" circuit designs, and I'm looking to hire someone to help out. I'm trying to keep costs low for my personal project, so please keep this in mind for the circuits. Please email me at jay at doscher dot com with your fees and general qualifications.

Here's what I need for each circuit:
1.) A schematic I can use to wire up the circuit on a breadboard
2.) A Gerber PCB file set for each circuit for potential future PCB prototyping.
3.) Parts list for each design

Here are the circuits I need help with:
A.) Accelerometer circuit interface to a BeagleBone (Need to measure the angle of a plane in relation to the ground)
B.) DC measurement circuit for measuring up to 20V, 10A DC sources, send volts/amps readings to Beaglebone
C.) Compass circuit - need to determine heading and communicate value to Beaglebone

Each circuit project will be treated as a standalone project, and time will be needed to order parts and test designs. I am open to sharing these under Open Hardware with attribution to the designs going to you. Most circuits can leverage existing kits or break-out boards, but all the current schematics and designs are for Arduino- I need them for Beaglebone.

Interested? Please PM or Email me to the address provided above.

[adafruit_support_bill]

You might want to post this on the "jobs" board.
http://www.adafruit.com/jobs/

[jdoscher]

You might want to post this on the "jobs" board.
http://www.adafruit.com/jobs/

Oops, will do. Thanks!