Atmega 88 programming using usbasp / avrdude

[avo3]

Hello,
First of all I`m new guy so sorry for some mistake which I will surely do.
I almost build the working wavebubble. But when I check the usart communication nothing work.
I use usbasp programmer and avrdude software.
First I burn the fuses like here:
http://www.ladyada.net/make/wavebubble/tuning.html
and evey test work geat except uart test.
I use putty for the comunication with board.
I the boadr with ft232 work`s great I checked.
There is some interestin think about programing using avrdude.
First as I sad program the fuses then I download to ucontroler program with uncommented test uart.
At the last line of software avr dude ask me that the fuses have been changed and if I would like to re-program it back.
So I choose yes I try to stay in this which program suggested but it just go worse because it block my u controller.
Thank You for help me.

[spacedoggy]

take a load of screen shots or list the output you get when programming.

post screen shots of your terminal settings and screen too.

[avo3]

hello,
thank You for Your fast answer I attached screen shot

[spacedoggy]

here's the notes I used when programming my rev 1.0a

Code: Select all

cd C:\WinAVR-20100110\bin\WB_firmwarev1

edit main.c parameters, uncomment out calls to individual test functions...
notepad main.c

set fuses... (may require configuration of command line from default)
make burn-fuse

compile make.c...
make

test programmer connection...
avrdude -p atmega88 -P usb -F -c avrispmkii

write EEPROM...
avrdude -p atmega88 -P usb -F -c avrispmkii -u -U eeprom:w:wavebubble.eep

Write flash...
avrdude -p atmega88 -P usb -F -c avrispmkii -u -U flash:w:wavebubble.hex



and my WB2010...

Code: Select all

cd C:\WinAVR-20100110\bin
previous version located here: C:\WinAVR-20100110\bin\WB2010_Firmware

set fuses... (varify values before re-running fuse programming should be E2 D5 F9 on fusecalc)
avrdude -c avrispmkii -p atmega168 -P usb -U lfuse:w:0xe2:m -U hfuse:w:0xd5:m -U efuse:w:0xf9:m

test programmer connection...
avrdude -c avrispmkii -p atmega168 -P usb

test firmware...
cd C:\WinAVR-20100110\bin\WB2010_Hardware_Test
avrdude -c avrispmkii -p atmega168 -P usb -U flash:w:main.hex

build firmware...
cd C:\WinAVR-20100110\bin\WB2010_Firmware
avrdude -c avrispmkii -p atmega168 -P usb -U flash:w:main.hex



[avo3]

hello, thank You for Your answer I have big request for You,
could You send me this .eep and .hex files for v1.0a (RC1a) with runing normal program as should be.
my e-mail avo3@poczta.onet.pl
THANK YOU