change chip select on Assembled Data Logging Shield?

For other supported Arduino products from Adafruit: Shields, accessories, etc.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
sketchy
 
Posts: 285
Joined: Thu Jun 28, 2012 11:37 pm

change chip select on Assembled Data Logging Shield?

Post by sketchy »

I am using Adafruit's Assembled Data logging shield for Arduino.

Is it possible to change the chip select pin from pin 10 (I am using an Arduino Uno)? If so, what are the steps to do so?

User avatar
adafruit_support_bill
 
Posts: 88037
Joined: Sat Feb 07, 2009 10:11 am

Re: change chip select on Assembled Data Logging Shield?

Post by adafruit_support_bill »

Yes. You can cut the trace between pin 10 and the adjacent breakout hole. Then you can run a jumper from the hole labeled "CS" to any other pin.

Image

Locked
Please be positive and constructive with your questions and comments.

Return to “Other Arduino products from Adafruit”