Atmega32u4 breakout board, typo on product description?

[auzieman]

Correct me if I am wrong but the Atmega32u4 breakout board can use the USB connector for power right?

Also, and again pardon my ignorance but we can't use the IDE directly with this board? I saw a posting that sounded like you could but you had to compile then copy the hex file from the temp space and use averdude to send it to the board? Ideally I would like to just use the IDE from the arduino project. (but will use alternate if need be.)

Thanks in advance,
Auzieman

[adafruit]

you can use the arduino IDE if you install teensyduino. we're using v19 and it works fine. follow our tutorial

it is powered over USB

[auzieman]

Thanks much,
Now if only I could buy some of those cheap Chinese servos through you I'd have my shopping all done Once I get it all up and running I'll blog about it on my blogspot profile.

[adafruit]

we have servos in the robotics category, they are fairly inexpensive and we make sure the quality is good