Decay not working! (solved)

by **safetyboy** » Wed Dec 22, 2010 3:53 pm

looked around for shorts but cant seem to find any!!

by **mome rath** » Wed Dec 22, 2010 4:32 pm

is the pot good?

by **Altitude** » Wed Dec 22, 2010 8:54 pm

by **guest** » Thu Dec 23, 2010 2:42 am

is the decay stuck short or long
does the accent work fine

by **safetyboy** » Thu Dec 23, 2010 4:37 am

Accent works fine, as does everything else. I will do some testing later when i get home.

by **aminoacid** » Thu Dec 23, 2010 9:59 am

see that you havnt mixed the res pot and the decay pot together!

by **safetyboy** » Wed Jan 05, 2011 6:13 pm

aminoacid wrote:see that you havnt mixed the res pot and the decay pot together!

Whats the handiest pins to measure the resistance of the decay pot?

by **guest** » Wed Jan 05, 2011 7:01 pm

there are only three pins which are not connected to ground
measure the resistance across the outer two of these

by **Brassteacher** » Wed Jan 05, 2011 8:40 pm

mome rath wrote:is the pot good?

Well, if it isn't, I certainly won't be able to help this time, agriculture and botany are not things in which I am well-versed.

by **safetyboy** » Thu Jan 06, 2011 6:40 pm

Looking like the Res and Dec pots are mixed up! Ouch!

by **Brassteacher** » Thu Jan 06, 2011 9:21 pm

safetyboy wrote:Looking like the Res and Dec pots are mixed up! Ouch!

Just take your time removing them, don't get in a hurry or you may pull up traces from the board. Other than that, it's no big deal.

by **Altitude** » Thu Jan 06, 2011 10:00 pm

I've done this a few times and I just pry up a corner a little at a time while heating the nearest pin

by **safetyboy** » Sat Jan 08, 2011 3:00 pm

Swapped and fixed and sounding \o/ !!! cheers all!