Lesson 3 using Arduino Uno

by **haveavoice** » Wed Apr 13, 2011 1:37 pm

I'm going through lesson 3:
http://www.ladyada.net/learn/arduino/lesson3.html

And I can't mimic this:
http://www.ladyada.net/images/arduino/b ... eldled.jpg
because my board doesn't have the holes to the right:
http://www.makerbench.com/makerbench/wp ... _Front.jpg

Where is everything being plugged into exactly?

by **adafruit_support_bill** » Wed Apr 13, 2011 1:41 pm

That is a prototyping shield mentioned in the "Get your gear" section at the top of the tutorial.

by **haveavoice** » Wed Apr 13, 2011 4:38 pm

That makes a lot of sense it looks really similar to the A.Uno. Another quick question, I'm trying to replicate this it by using this page: http://www.ladyada.net/make/pshield/.. but what "connects" the shield to the A.Uno? And are the red end green LEDs bent and not connected anywhere in the A.Uno so it can fit on top?

by **adafruit_support_bill** » Wed Apr 13, 2011 5:10 pm

It is attached to the Arduino via pin headers. The instructionsshow you how to assemble the proto-shield. You will need some basic tools such as a soldering iron. http://www.ladyada.net/library/equipt/kits.html

by **haveavoice** » Fri Apr 15, 2011 9:48 am

Thanks a lot I didn't even think looking to the left for the navigation. I'll make sure to be more observant next time. Great instructions by the way!

Lesson 3 using Arduino Uno

Lesson 3 using Arduino Uno

Re: Lesson 3 using Arduino Uno

Re: Lesson 3 using Arduino Uno

Re: Lesson 3 using Arduino Uno

Re: Lesson 3 using Arduino Uno

Who is online