one sided pcb

[oPossum]

Double sided

0.50 x 2.00 inches (1 sq. in.)





EAGLE files

[magician13134]

Someone (Ladyada I guess) should start a sticky with all the different PCB designs in it, and them pictures of the final if anyone's made it. That'd be pretty helpful to anyone looking to make their own

[Probedude]

oPossum,
You've got two pads really close together where the electrolytic cap is between the IR leds. What's the other pad for?

[caitsith2]

If you look in the schematic, he is covering for 2mm (79mil) lead spacing caps, as well as 2.54mm (100mil) lead spacing caps.

[Probedude]

If you look in the schematic, he is covering for 2mm (79mil) lead spacing caps, as well as 2.54mm (100mil) lead spacing caps.

Thanks, didn't notice that. Some board houses will complain about 2 holes being too close together due to possible breakout and then bit breakage. At first glance these adjacent holes jumped out at me.

I just looked up ExpressPCB's specs and it's:

> A minimum of 0.021" space must remain between adjacent holes. For example, the center-to-center distance between two pads with 0.020" holes must be 0.041" or greater.

[CJM]

Hello,

I would like Opossums board etching,
because of the ISP problem, however, I would like to be the jumper resistors.

I have the whole thing with EAGLE tried, but due to lack of experience nothing.

Could you please according to the circuit times for me?

Maybe the Jasonx?


Thank you






PS:
I hope you understand that G00gl € - English