I am half way fabricating the VCO. In attachment you see the saw tooth waveform. Is this looking good or what could be wrong? I am asking because I am missing the vertical lines.
Kit bought at x0xsh0p.de, 3V source is watch battery, using this manual.
Thanks for any help.
Saw tooth waveform looking good?
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- jorrit
- Posts: 5
- Joined: Sat Jun 03, 2017 2:04 pm
Saw tooth waveform looking good?
- Attachments
-
- WhatsApp Image 2017-06-03 at 20.02.43 (Small).jpeg (53.07 KiB) Viewed 969 times
- antto
- Posts: 1636
- Joined: Thu Apr 15, 2010 3:21 pm
Re: Saw tooth waveform looking good?
that's fine
you won't see the vertical line on this CRT scope
it's a very short transition, so the beam has almost no time to leave a bright enough trace on the screen
you won't see the vertical line on this CRT scope
it's a very short transition, so the beam has almost no time to leave a bright enough trace on the screen
- jorrit
- Posts: 5
- Joined: Sat Jun 03, 2017 2:04 pm
Re: Saw tooth waveform looking good?
All right, thank you
Please be positive and constructive with your questions and comments.