It's ­čÉŹCircuitPython Monday­čÉŹ at Adafruit! Use the code ADATY to get 20% off CircuitPython and 15% off items storewide!
0

Conflicting Capacitor Part Number
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Conflicting Capacitor Part Number

by Camshaft on Mon May 11, 2020 11:29 pm

I'm building the RC1a version of the Wave Bubble and have been using Limor's instructions. I noticed when I was getting the parts for the battery board one of the capacitors listed, C2, was conflicting with the description of the capacitor. The part # listed is UWT0J221MCL1GB which is a 6.3v 220uF cap, but the description says it should be a 6.3v 100uF cap. Does anyone know if I should follow the part number or the description? I'm not super experienced with the Wave Bubble so I could be wrong about this.

Camshaft
 
Posts: 2
Joined: Tue Apr 07, 2020 1:15 pm

Re: Conflicting Capacitor Part Number

by Tritronic on Sat Feb 13, 2021 1:02 pm

How did that go? Any conclussions?

Tritronic
 
Posts: 1
Joined: Sat Feb 13, 2021 1:01 pm

Re: Conflicting Capacitor Part Number

by Camshaft on Sat Feb 13, 2021 1:15 pm

I kind of gave up on this project at least for the time being because I just don't think it's that feasible in 2021. A lot of the parts were quite difficult to find (thankfully not too expensive) and many parts should be updated. I don't have a ton of experience with this, but I think it would be amazing if someone were to make a 2021 updated version of the wave bubble.

Camshaft
 
Posts: 2
Joined: Tue Apr 07, 2020 1:15 pm

Please be positive and constructive with your questions and comments.