Wave Bubble 2010 Moderators: adafruit_support_bill, adafruit

[Mictronics]

The basic design is proved to work. For now I see no advantage in another design changes.

[mattyciii]

I'd be interested in buying a bare board if there is a group but too.

[b1nary]

I would be interested in the order of the pcb order

[Durgo]

Count me in for an order of black PCBs!

[erich81]

I'd also be interested in a set of boards for the updated design, as I was trying to figure out how to panelize layouts before submitting, but if we all order it'll be cheaper than individually doing it.

If they aren't that expensive, I'd be in for 2 sets. Haven't touched electronics in a long time, but as I work for an RFID company, reading the posts in here and doing some of the projects is really teaching me a lot. I'd be interested to see a design that does include a LCD that could maybe show frequencies being jammed, voltage levels/charge state, etc.

also, only the schematics for the power board seem to be available, does anyone have the full panel PCB .BRD or gerber files, ready to send to manufacturer, preferably already in a panel file so I can submit just one file?

[Mictronics]

Schematic and layout for the main board will be released when I'm done with all test's and programming.

An LCD is not planed and in my opinion not needed, but the SPI on the ISP connector is free so one can hook up a Nokia graphic LCD from a cell phone there.

[erich81]

Sounds good. Thanks for spending the time to share your revised work with the community. Do you have any update on group order for the boards?

[Palmer Eldritch]

Is it too late to get in on the order? I'd like to get 2 boards please!

TX/RX Labs members will love them...

[Mictronics]

Update the wiki with schematic, board file and pictures of the main board. Believed to be error free. Automatic DRC reports nothing.

Source code and firmware for hardware test will be next.

[crease-guard]

I would be interested in several sets of these boards when you are ready to do a run.

Jay

[coolman2024]

I too would like a couple sets of boards if it is not too late

[antman]

I would love to buy a set of the pcb's as well. Please advise if their are any of the sets available.

[ahmed]

I am trying to make a jammer
I want to ask is sawtooth directly given to vco ,or there is some dc adjustmant made by atmega microcontroller
so that sweep must trace bursts and cater for handover

[Mictronics]

I am trying to make a jammer
I want to ask is sawtooth directly given to vco ,or there is some dc adjustmant made by atmega microcontroller
so that sweep must trace bursts and cater for handover

The sawtooth is modulated on an adjustable DC offset. The DC offset will set the centre frequency of your sweep, the sawtooth will set the bandwidth around the centre frequency.

@ All
AFAIK nobody did a PCB batch run so far. But I will no do, but there was already an offer from someone else.

[cofhal]

I need buy the pcb board for this proyect