0

Zero4U pin missalignment
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Zero4U pin missalignment

by AKman on Tue Sep 12, 2017 6:51 pm

Order 1528339 in August 28, 2017

Zero4U - 4 Port USB Hub for Raspberry Pi Zero v1.3 : [ID:3298]
PP 23 & 22 are too close together and a few mm too close to the two pins PP1 & PP6.
The pins do not align and will not insert into the RP Zero.

I do not want to un/resolder them.

I purchased a RP0 in the same order. Pin port spacing is okay on the Pi.

See the photo attached.

What should I do?

Quinten
Attachments
Zero4u.jpg
Zero4u.jpg (776.34 KiB) Viewed 53 times

AKman
 
Posts: 2
Joined: Tue Sep 12, 2017 6:05 pm

Re: Zero4U pin missalignment

by adafruit_support_mike on Wed Sep 13, 2017 4:28 am

The Zero4U connects to the RasPi with its USB ports over the RasPi's GPIO header.

adafruit_support_mike
 
Posts: 43300
Joined: Thu Feb 11, 2010 2:51 pm

Re: Zero4U pin missalignment

by AKman on Wed Sep 13, 2017 1:47 pm

Got it. Thanks for your help.

Quinten

AKman
 
Posts: 2
Joined: Tue Sep 12, 2017 6:05 pm

Please be positive and constructive with your questions and comments.