Patch Cable for I2C and LTC4311
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 7
- Joined: Sun Dec 15, 2013 12:31 pm
Patch Cable for I2C and LTC4311
I am about to implement an Adafruit LTC4311 active terminator. Tutorial https://learn.adafruit.com/adafruit-ltc ... terminator reports good results by using an Ethernet cable. Is it recommended to use a twisted pair of that cable for SDA and SCL, e. g. TX+ and TX-? Since SDA and SCL are carrying different signals, this may be counter-productive, and I should rather feed them through cores that are not intertwined with each other, e. g. TX+ and RX+? Thanks for any suggestion.
Please be positive and constructive with your questions and comments.