BNO055 calibration Moderators: adafruit_support_bill, adafruit

[theaddies]

My BNO055 calibrates to output accel = 3, gyro = 3 and mag = 3. But the Sys still stays at 0. Is that even possible? I thought that the sys was simply dependent on the others. I have had it calibrate with no problem this just started to happen yesterday. Normally it would take about 3 or 4 seconds of movement to get the mag to a 3 and then the sys would kick to 3 right away. TIA.

[wolfmanjm]

According to Bosch there is a bug in the f/w and they suggest do not use the SYS calibration but instead use the other ones.

https://community.bosch-sensortec.com/t ... /true#M926