Due to high demand, expect some shipping delays at this time - orders may not ship for up to 2-3 business days.
0

BNO055 calibration
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

BNO055 calibration

by theaddies on Fri Jan 28, 2022 12:24 pm

My BNO055 calibrates to output accel = 3, gyro = 3 and mag = 3. But the Sys still stays at 0. Is that even possible? I thought that the sys was simply dependent on the others. I have had it calibrate with no problem this just started to happen yesterday. Normally it would take about 3 or 4 seconds of movement to get the mag to a 3 and then the sys would kick to 3 right away. TIA.

theaddies
 
Posts: 35
Joined: Sun Jan 13, 2013 1:25 pm

Re: BNO055 calibration

by wolfmanjm on Fri Jan 28, 2022 2:30 pm

According to Bosch there is a bug in the f/w and they suggest do not use the SYS calibration but instead use the other ones.

https://community.bosch-sensortec.com/t ... /true#M926

wolfmanjm
 
Posts: 2
Joined: Fri Oct 10, 2014 2:55 am

Please be positive and constructive with your questions and comments.


cron