0

adafruit tpl5111 configuring it in one-shot mode
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

adafruit tpl5111 configuring it in one-shot mode

by jimhampton on Mon Sep 16, 2019 12:33 pm

adafruit tpl5111 configuring it in one-shot mode

I see that pin 6 on the TPL5111 must be tied low to enable one-shot mode and I don't see an easy way other than lifting pin 6 (without destroying it) and grounding it. I need the output enable to stay high (not pulse) as it is re-triggered externally and after 5 min of no triggering go low and stay that way.

Jim Hampton

jimhampton
 
Posts: 1
Joined: Mon Sep 16, 2019 12:14 pm

Please be positive and constructive with your questions and comments.