Currently, I'm working on a project where I'm using an nRF9160 Feather board to take pictures with the VC0706 and upload the images through LTE.
With the nRF9160 Feather board, the firmware runs like a charm and everything is working fine. When initiating the reset function these are the messages in the terminal:
Code: Select all
Camera VC0706
Initializing camera
v(NUL)
&(NUL) (NUL)
VC0703 1.00
No ctrl infr
MI360525
Init end
Code: Select all
Camera VC0706
Initializing camera
v(NUL)
&(NUL) (NUL)
VC0703 1.00
No ctrl infr
MI360
525
Init end
When booting up the board and camera this is what comes up in the terminal:
Code: Select all
Camera VC0706
Initializing camera
v(NUL)
&(NUL) (NUL)
Error during reset: -1
VC0703 1.00
Ctrl infr exist
User-defined sensor
525
Init end
The hardware should be the same and the firmware is the same, so I do not understand what "settings" made this change happen.
Does anyone know what this change means and how to adjust it to the "correct" setting?