There is no USPS pickup on Monday Feb 15th, 2016 because of President's Day. USPS orders placed after 11am EST Fri February 12th will go out Tuesday February 16. UPS orders will ship as normal.

Solenoid circuit question
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Solenoid circuit question

by dustynrobots on Mon Dec 03, 2012 10:18 pm

So I have a small solenoid from Adafruit and I hooked it up as in the diagram here and it works: ... driver.pdf

However, I first had it hooked up with the solenoid and the transistor order reversed so inline from power it was:

and it did not work. So my question is why would this NOT work? I'm happy it works now of course, but would appreciate any insight since I can't come up with a reason why it didn't work in this configuration. Thanks!

Posts: 26
Joined: Fri Jul 22, 2011 5:43 pm
Location: New York, NY

Re: Solenoid circuit question

by adafruit on Mon Dec 03, 2012 10:22 pm

a NPN transistor is on when the the base is about .7V above the emitter. if you connect the emitter to ground, then you can pull the base up to 0.7v. if the emitter is 'floating' or connected to an inductor (which, when turning on, is an instant short but then turns into an open) then the base wont be steady. thats the short answer, for more details, check horowitz & hill, chapter 1 & 2

Posts: 12047
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc

Please be positive and constructive with your questions and comments.