Hello Adafruit! I have bought a number of your UV sensor breakout boards, and they are very nice, but I would like to use the sensor in my own product and am hoping you could share with me where you got the raw sensor? Do I have to order 1000+ from Rothnier Technik? Failing that, cheapest thing I can come up with is to order a knockoff boards from China, and place them in the reflow oven to get the parts off. I don't like the idea of subjecting the part to three thermal cycles, though.
Your help would be greatly appreciated! Here's my current project using a raw SI1132. What a pain to place and solder that part!
source for GUVA-S12D
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: source for GUVA-S12D
I'm afraid our supplier contracts forbid sharing that information with third parties.
- uhclem
- Posts: 107
- Joined: Sun Jul 08, 2007 6:03 pm
Re: source for GUVA-S12D
Looks like there is a genuine:
http://www.roithner-laser.com/datasheet ... -s12sd.pdf
And a knockoff or Chinese reseller (not sure which):
http://www.seeedstudio.com/wiki/images/ ... -S12SD.pdf
Oh well, at least you have a board to get me started. I'm sure I just have to buy 1000 to get it from the source.
http://www.roithner-laser.com/datasheet ... -s12sd.pdf
And a knockoff or Chinese reseller (not sure which):
http://www.seeedstudio.com/wiki/images/ ... -S12SD.pdf
Oh well, at least you have a board to get me started. I'm sure I just have to buy 1000 to get it from the source.
Please be positive and constructive with your questions and comments.