0

Gemma V2 Bootloader Issue
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Gemma V2 Bootloader Issue

by didichan31 on Tue Dec 13, 2016 7:57 pm

Hello,

When plugging in my Gemma into my laptop, the red LED used in the bootloader is dim, and then the board isn't recognized. I don't have an Arduino UNO (yet, but I plan to exchange my raspberry pi a+ for store credit in order to buy the uno). Is there any other way to repair the bootloader without using the Uno?

didichan31
 
Posts: 7
Joined: Thu Oct 06, 2016 10:23 pm

Re: Gemma V2 Bootloader Issue

by mike3d0g on Fri Dec 16, 2016 3:40 pm

I can tell you that the Trinket Loader program didn't run on my Arduino Mega 2560, but it ran fine on an Arduino Uno R3. You might just have to suck it up and buy a Uno (that's not so bad). I don't know if it would run on Uno variants like the Uno Ethernet, which I think uses the same processor.

mike3d0g
 
Posts: 10
Joined: Mon Mar 30, 2015 3:33 pm

Please be positive and constructive with your questions and comments.