I decided to bust out my Trinket Pro for a project that I'm working on. I went to set everything up (download the Arduino IDE 1.8.5, download and install the USBTiny Windows drivers) and I hit a snag. As always, I consulted the BANNED, Google. Results brought me here, naturally, but most of them were outdated (5+ years back) or for previous versions of Windows.
So, here is the problem. I plugged my device in, Windows chimes off that it recognizes a USB device. I open up devmgmt and I see the libusb and USBTiny like it's supposed to be but then I hear the chime again and it disappears. I'm fairly confident the driver is installed correctly against the device. I've tried different USB ports, restarting the device, and reinstalling the driver.
I am using Ardiuno IDE v1.8.5, libusb-win32 v1.2.6, Windows 10 on a 64 bit Intel i7-4720 platform.
Could anyone provide some insight or direction because I'm a little stumped.
Thanks!
Windows 10 issues recognizing the Trinket Pro
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- eavery6156
- Posts: 25
- Joined: Thu Jul 31, 2014 10:53 am
- adafruit_support_bill
- Posts: 88145
- Joined: Sat Feb 07, 2009 10:11 am
Re: Windows 10 issues recognizing the Trinket Pro
The USBTiny device emulation is performed by the bootloader. When the bootloader times out, the USBTiny device goes away. You need to start your upload when the USBTiny is active. You can re-activate the bootloader by pressing the reset button.
- eavery6156
- Posts: 25
- Joined: Thu Jul 31, 2014 10:53 am
Re: Windows 10 issues recognizing the Trinket Pro
I do recall that with other devices, too.
My concern was making sure the compiler could recognize and talk to the device. I'll give it a shot and see what happens.
My concern was making sure the compiler could recognize and talk to the device. I'll give it a shot and see what happens.
- eavery6156
- Posts: 25
- Joined: Thu Jul 31, 2014 10:53 am
Re: Windows 10 issues recognizing the Trinket Pro
That was it, my man,
I'm ready to rock and roll. Thanks for the help!
I'm ready to rock and roll. Thanks for the help!
- adafruit_support_bill
- Posts: 88145
- Joined: Sat Feb 07, 2009 10:11 am
Re: Windows 10 issues recognizing the Trinket Pro
Good to hear you've got it working. Thanks for the follow-up.
- tobink64
- Posts: 14
- Joined: Sun Jan 21, 2018 1:55 pm
Re: Windows 10 issues recognizing the Trinket Pro
I sort of the the same issue. I plug my trinket into a usb hub and boot load , My computer recognizes trinketboot, however when I load "adafruit-circuitpython-trinket_m0-2.2.1.uf2", it disappears and does not come back. I look in the computer directerory and it is not in there.
- adafruit_support_bill
- Posts: 88145
- Joined: Sat Feb 07, 2009 10:11 am
Re: Windows 10 issues recognizing the Trinket Pro
@tobink64 - The M0 is not a USBtinyISP device. Better to post this question in the CircuitPython forum --> viewforum.php?f=60
- tobink64
- Posts: 14
- Joined: Sun Jan 21, 2018 1:55 pm
Re: Windows 10 issues recognizing the Trinket Pro
Sorry about that.
Please be positive and constructive with your questions and comments.