Uno R3 pin solder question

For makers who have purchased an Adafruit Starter Pack, get help with the tutorials here!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
onionsniper
 
Posts: 1
Joined: Tue Sep 13, 2016 2:48 pm

Uno R3 pin solder question

Post by onionsniper »

Total newbie here -- ordered the ARDX - v1.3 Experimentation Kit for Arduino (Uno R3) (v1.3) to get started.

When I popped it open, it appears that the 6 pins labeled as "ICSP" are soldered offset by 1. I've attached a photo. Definitely looks incorrect, but I wanted to ask, since I'm new to this...
pins offset and angled...
pins offset and angled...
uno_r3_pins.jpg (537.89 KiB) Viewed 990 times

User avatar
adafruit_support_bill
 
Posts: 88093
Joined: Sat Feb 07, 2009 10:11 am

Re: Uno R3 pin solder question

Post by adafruit_support_bill »

Whoa! That is a problem. It won't be a problem for most of the lessons in the ARDX kit, but will definitely interfere with plugging in shields. If you contact [email protected] with a link to this thread, we can replace the board.

Locked
Please be positive and constructive with your questions and comments.

Return to “Arduino Starter Pack”