I'm going through lesson 3:
http://www.ladyada.net/learn/arduino/lesson3.html
And I can't mimic this:
http://www.ladyada.net/images/arduino/b ... eldled.jpg
because my board doesn't have the holes to the right:
http://www.makerbench.com/makerbench/wp ... _Front.jpg
Where is everything being plugged into exactly?
Lesson 3 using Arduino Uno
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88099
- Joined: Sat Feb 07, 2009 10:11 am
Re: Lesson 3 using Arduino Uno
That is a prototyping shield mentioned in the "Get your gear" section at the top of the tutorial.
-
- Posts: 10
- Joined: Fri Mar 18, 2011 5:13 pm
Re: Lesson 3 using Arduino Uno
That makes a lot of sense it looks really similar to the A.Uno. Another quick question, I'm trying to replicate this it by using this page: http://www.ladyada.net/make/pshield/.. but what "connects" the shield to the A.Uno? And are the red end green LEDs bent and not connected anywhere in the A.Uno so it can fit on top?
- adafruit_support_bill
- Posts: 88099
- Joined: Sat Feb 07, 2009 10:11 am
Re: Lesson 3 using Arduino Uno
It is attached to the Arduino via pin headers. The instructionsshow you how to assemble the proto-shield. You will need some basic tools such as a soldering iron. http://www.ladyada.net/library/equipt/kits.html
-
- Posts: 10
- Joined: Fri Mar 18, 2011 5:13 pm
Re: Lesson 3 using Arduino Uno
Thanks a lot I didn't even think looking to the left for the navigation. I'll make sure to be more observant next time. Great instructions by the way!
Please be positive and constructive with your questions and comments.