Hello, I am having an issue where the motor shield (V1) will run the example sketch and fluctuate between 0v and 12v at the specified motor output, but it won't go to -12v. This is the basic motor test example sketch (unmodified). Obviously the motor will not the go into reverse only forward and stop. Is there something obvious I'm missing here?
Thanks
Motor Shield V1 Backwards problem
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88037
- Joined: Sat Feb 07, 2009 10:11 am
Re: Motor Shield V1 Backwards problem
Please post photos showing your soldering and connections to the shield.
Please be positive and constructive with your questions and comments.