๐Ÿ“ฃ๐Ÿ“ช ๐Ÿšš Adafruit will not be shipping USPS orders Monday October 14, 2019 ๐Ÿ—“. Expedited USPS orders placed after 11am ET ๐Ÿ•š Friday October 11 will go out Tuesday October 15 ๐Ÿ“ฃ๐Ÿ“ช๐Ÿšš

chipset question
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

chipset question

by 0nIC on Wed Feb 13, 2008 2:11 am

I've been loving the TV-b_Gone kits for over a month now. Mine was so popular with my friends that I have built over 5 of them now (not a huge number i know)

Anyways, heres my big question. The little chip holder (i'm drawing a blank on the name) for the flash memory, is it possible for the board to function without it? That I mean, if I directly solder the chip to the board, will the whole thing still function properly?

I ask this because i am experimenting in hiding the device in common items. I do not want to go into too much detail because I want to show you guys my finished project when I am done.

-- Do whatcha like, like whatcha do.
Posts: 1
Joined: Wed Feb 13, 2008 2:04 am

by TheDon125 on Wed Feb 13, 2008 2:21 am

The socket you mean? Yeah, its perfectly fine to do without that. Just need to be slightly more careful not to overheat the chip. I'm pretty sure it is just there so that you run no risk of overheating the chip while soldering it in, and also so that you can easily remove the chip if later you want to reprogram it with more codes.
Posts: 23
Joined: Tue Jan 09, 2007 9:58 pm

Please be positive and constructive with your questions and comments.