However now I need to upload the TV-B-Gone firmware. However it is a hex file and I cannot see a way of uploading that through the arduino IDE.
So i tried avrdude directly:
Code: Select all
/usr/bin/avrdude -c arduino -p attiny85 -P /dev/ttyUSB0
Code: Select all
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e950f (probably m328p)
avrdude: Expected signature for ATtiny85 is 1E 93 0B
Double check chip, or use -F to override this check.
avrdude done. Thank you.
Also as a side note:
How do I configure it to use one or the other?The v1.2 kit can be configured for either N.A. and EU zone which avoids this problem!