0

Feather M0 RFM69 not accepting upload
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Feather M0 RFM69 not accepting upload

by radioman12 on Tue Nov 27, 2018 11:50 am

Hello, I uploaded the demo sketch(TX on one, RX on another) and it worked fine. I then added DHT sensor and updated sketch to show the DHT humidity and temperature in the console. That worked fine. Next day now and I was first going to verify it was all still working as it did yesterday, then work on getting it to transmit that data; however, the board isn't accepting uploads now. Arduino IDE provides the following message.
Set binary mode
No device found on cu.usbmodem14101
Set binary mode
An error occurred while uploading the sketch.

LED is steady on. Port shows /dev/cu.usbmodem14101 (Adafruit Feather M0) in Tools. Arduino IDE is reading the board info when I click on Get Board Info

Using the same computer, I am able to upload to the other board.

Any ideas how to get the board to accept new uploads?
Thank you for any assistance you can provide.

radioman12
 
Posts: 3
Joined: Tue Nov 27, 2018 11:45 am

Please be positive and constructive with your questions and comments.