0

Flora to FeatherWing relay
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Flora to FeatherWing relay

by MorganMorgan on Wed May 22, 2019 4:57 pm

I am attempting to use a Flora to interface into a FeatherWing relay.
When the input from a pressure resistance fabric is struck by a ball, I need a 2-3 second relay closure to operate a bell and buzzer.
Does anyone have a wiring diagram or suggested connection ?
Thanks
Gary

MorganMorgan
 
Posts: 2
Joined: Wed May 22, 2019 1:05 pm

Re: Flora to FeatherWing relay

by adafruit_support_mike on Thu May 23, 2019 12:22 pm

You’ll need to connect the Flora’s 3.3V and GND pins to the corresponding pins on the Relay FeatherWing (next to the reset button), then connect with one of the Flora’s GPIO pins to the Signal pin in the center of the FeatherWing.

adafruit_support_mike
 
Posts: 58335
Joined: Thu Feb 11, 2010 2:51 pm

Re: Flora to FeatherWing relay

by MorganMorgan on Thu May 23, 2019 1:22 pm

Perfect, Just what I needed to know.
Thank You !!

MorganMorgan
 
Posts: 2
Joined: Wed May 22, 2019 1:05 pm

Please be positive and constructive with your questions and comments.