I am attempting to use a Flora to interface into a FeatherWing relay.
When the input from a pressure resistance fabric is struck by a ball, I need a 2-3 second relay closure to operate a bell and buzzer.
Does anyone have a wiring diagram or suggested connection ?
Thanks
Gary
Flora to FeatherWing relay
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Flora to FeatherWing relay
You’ll need to connect the Flora’s 3.3V and GND pins to the corresponding pins on the Relay FeatherWing (next to the reset button), then connect with one of the Flora’s GPIO pins to the Signal pin in the center of the FeatherWing.
- MorganMorgan
- Posts: 2
- Joined: Wed May 22, 2019 1:05 pm
Re: Flora to FeatherWing relay
Perfect, Just what I needed to know.
Thank You !!
Thank You !!
Please be positive and constructive with your questions and comments.