Hi, I purchased a UPS board. As you can see from the attached image there is an on/off toggle switch. i will be putting this kit inside a case and i want to let my customer move this switch. But it is quite small/fiddly. Would you know of any extension I could use please?
Thanks
Adapter Swicth
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- dommy123
- Posts: 5
- Joined: Sun Apr 18, 2021 12:22 pm
Adapter Swicth
- Attachments
-
- Image if UPS with switch
- ww.jpg (251.49 KiB) Viewed 257 times
- blnkjns
- Posts: 963
- Joined: Fri Oct 02, 2020 3:33 am
Re: Adapter Swicth
Any two-way rocker switch or momentary push button will work if you don't mind soldering 2 wires to the pads after removing the current switch.
https://www.adafruit.com/product/916
https://www.adafruit.com/product/3221
https://www.adafruit.com/product/916
https://www.adafruit.com/product/3221
- dommy123
- Posts: 5
- Joined: Sun Apr 18, 2021 12:22 pm
Re: Adapter Swicth
Hi
Yes, thanks for your suggestion. I already have those switches but I did not want the switch to be that big. I was hoping to find some sort of 'sleeve' to place on top of the existing one and with the same type of dimensions as the original but just taller.
thanks again for your reply.
Yes, thanks for your suggestion. I already have those switches but I did not want the switch to be that big. I was hoping to find some sort of 'sleeve' to place on top of the existing one and with the same type of dimensions as the original but just taller.
thanks again for your reply.
- Franklin97355
- Posts: 23940
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Adapter Swicth
This might help https://www.adafruit.com/product/3870
Please be positive and constructive with your questions and comments.