I adjusted the baud to 9600 and the test works fine without arduino and just plugging it straight into power. But when I try to upload A_printertest it barely prints anything. Only works for a second. What am I doing wrong? I edited to baut on TextEdit. Photos are attached.. please help!
oh also, im using an orange wire instead of green ha ha.
Arduino Nano thermal printer not working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- gracehoran
- Posts: 3
- Joined: Wed Apr 04, 2018 9:43 pm
Arduino Nano thermal printer not working
- Attachments
-
- IMG_4614.jpg (489.13 KiB) Viewed 113 times
-
- IMG_4613.jpg (376.71 KiB) Viewed 113 times
Please be positive and constructive with your questions and comments.