Working on a small project where I want to stop the iris movement based on the light sensor. I have the uncanny eyes config.h set the way I want (iris max and min set at 200) but when I try to load it to my Hallowing I get the following.
Arduino: 1.8.7 (Mac OS X), Board: "Adafruit Hallowing M0"
sketch/uncannyEyes.ino.cpp:1:21: fatal error: Arduino.h: No such file or directory
#include <Arduino.h>
^
compilation terminated.
exit status 1
Error compiling for board Adafruit Hallowing M0.
I've reloaded the libraries, checked everything I know how, and I can get past this.
Any ideas, or a way to quickly edit the Eye_Newr.UF2? '
Thanks for assistance- Kevin
Arduino, Uncanny eyes, UF2, Hallowing, Arduino.h
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- kdn0184
- Posts: 4
- Joined: Fri Mar 23, 2018 9:04 am
- adafruit_support_carter
- Posts: 29168
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Arduino, Uncanny eyes, UF2, Hallowing, Arduino.h
Are you able to upload the blink sketch to the board? Just to make sure your basic setup is OK.
Please be positive and constructive with your questions and comments.