HW v1.1 errata
* Pin 7 (write protect) on the EEPROM needs to be explicitly pulled low. This prevents spurious write problems.
* Pin 5 of the ENC28J60 should be left unconnected, instead of being connected to an I/O pin on the propeller....according to the datasheet this pin will be internally pulled low if left unconnected... but apparently this isn't always the case.
Adding a haywire from pin7 (the only unconnected pin on the EEPROM) to a pin on the other side of the chip (which are all connected to VSS) fixed his problems.
I would recommend everyone doing the same at some point, especially before upgrading the bootloader if you don't have a prop-plug.
* Pin 8 on the pulsejack needs to be connected to GND, not VSS.
Bootloader v1.0 errata
* DHCP doesn't seem to work with Linksys WRT54G & WRT54GS routers with stock firmware. (Still under investigation. See this post for more info.)
* Green and blue LED's are swapped.
* TCP implementation doesn't retransmit packets
* You can't remove a password without doing a full reset. (Fixed in v804)