0

How to measuring Voltage with INA 260?
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

How to measuring Voltage with INA 260?

by elinter01 on Tue Oct 08, 2019 9:56 am

Hello everybody,

I'm currently working on an Arduino project and I'm asking myself if it's possible to measure the Voltage with the same ground for "Load" and "Source" (by means of the INA260)?
Or how to measure the voltage between the two black cables leaving the motordriver (look at the picture with the "V?") ?
Now I'm able to measure the current with the INA260 and it would be nice to measure also the voltage.


Note:
Load = heater
Source = DualVNH5019MotorShield
The one black cable which leaves at the "V?" is first connected with the INA260 then with the heater (Load).


Thanks.

Unbenannt.jpg
Setup
Unbenannt.jpg (265.67 KiB) Viewed 28 times

elinter01
 
Posts: 1
Joined: Tue Oct 08, 2019 8:51 am

Please be positive and constructive with your questions and comments.