Since the device is for servos, the chip says to insert a 5v power supply.
I already have the chip and just need to leverage its PWM capabilities and was wondering if I can pass up to 40v through the board.
If it is not possible to do you have any recommendations.
Thanks!
PWM Board - Adafruit 16-Channel PWM/Servo HAT
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- GAstraeus
- Posts: 1
- Joined: Mon Jun 21, 2021 12:10 pm
Please be positive and constructive with your questions and comments.