Bluefruit exit from Beacon mode
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- alpesh2559
- Posts: 3
- Joined: Fri Sep 25, 2015 12:47 am
Bluefruit exit from Beacon mode
hi..i use adafruit bluefruit LE (UART friend) with arduino protrinket board to control using android app to colour of neopixel using colour picker..i succefully work on app controller mode and able to change colour of neo pixel but one time i unfortunatly select beacon mode of app...so how to exit from becon mode of app...i uninstall app and reinstall so its still on beacon mode...i want to switch in controller mode....
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Bluefruit exit from Beacon mode
You can reset the unit to its original condition by connecting the DFU pin to GND for more than 5 seconds:
https://learn.adafruit.com/introducing- ... ia-dfu-pin
https://learn.adafruit.com/introducing- ... ia-dfu-pin
- alpesh2559
- Posts: 3
- Joined: Fri Sep 25, 2015 12:47 am
Re: Bluefruit exit from Beacon mode
but here issue in android app not in hardware undestand...app is run in becone mode continue if i uninstall and again reinstall than its open time continue show in becone mode
- alpesh2559
- Posts: 3
- Joined: Fri Sep 25, 2015 12:47 am
Re: Bluefruit exit from Beacon mode
i want to sitch over from becone mode to controller mode in android app...
- adafruit_support_mike
- Posts: 67485
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Bluefruit exit from Beacon mode
You should be able to choose 'Disconnect' in the app, then reconnect. When you do, the app should give you a list of ways you can connect to the device.
Please be positive and constructive with your questions and comments.