Defective Xbee unit
by craver2000 on Sat Mar 04, 2017 12:17 am
Hi, one of the XBee module that I purchased from Adafruit in Janurary has become defective. I am unsure of the cause as it has always been connected via a linear voltage regulator board. It is currently unable to receive or send signals but previously worked fine. When I connected it to my computer and attempt troubleshooting with XCTU, a dialog notified me of action required to reset the XBee. Thus, I used recovery mode in the XCTU software to reset the firmware. However, the problem still persists, and XCTU still prompts me to reset the module. I have tried resetting it for several times already. Please advise me on this issue.
- Attachments
-

- Photo 4-3-17, 2 37 22 pm.jpg (172.26 KiB) Viewed 772 times
-

- Photo 4-3-17, 2 29 31 pm.jpg (376.27 KiB) Viewed 772 times
-

- Photo 4-3-17, 2 29 14 pm.jpg (311.29 KiB) Viewed 772 times
Last edited by
craver2000 on Sun Mar 05, 2017 7:49 am, edited 3 times in total.