Trying to make a choice between DigiMesh ( XBP9B-DMST-002 ) and Point2MultiPoint ( XBP9B-DPST-001 ).
I will be sending commands from an arduino (controller) to RasPi (robot). Only the 2 nodes.
Which option would be better for such application?
Is the better question, when would P2MP (non-redundant) be superior/chosen over DigiMesh (redundancy)?
P2MP vs DigiMesh
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_bill
- Posts: 88042
- Joined: Sat Feb 07, 2009 10:11 am
Re: P2MP vs DigiMesh
If you only have 2 nodes, then the mesh capability does not buy you anything. You would need additional nodes to take advantage of any redundancy capabilities.
I would guess that the mesh protocol probably has somewhat more overhead than point-to-point. The folks over at the Digi forums can probably give you a more precise characterization of any performance benefits of one vs the other in your configuration.
https://www.digi.com/support/forum/
I would guess that the mesh protocol probably has somewhat more overhead than point-to-point. The folks over at the Digi forums can probably give you a more precise characterization of any performance benefits of one vs the other in your configuration.
https://www.digi.com/support/forum/
Please be positive and constructive with your questions and comments.