Voting resources, early voting, and poll worker information - VOTE. ... Adafruit is open and shipping.
0

USBtiny powers Monochron while trying to program it...
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

USBtiny powers Monochron while trying to program it...

by jamesey on Fri May 14, 2010 10:53 pm

I built my Monochron this afternoon without a hitch. Decided to replace the firmware with the Intruderchron using my USBtiny programmer and it worked fine.

However, then I tried to revert back to the original firmware and the programmer just seems to power the clock in normal operation, so it won't program (either when set to "power" or "not power" the target board). Anyone been through something similar?
jamesey
 
Posts: 1
Joined: Fri May 14, 2010 10:46 pm

Re: USBtiny powers Monochron while trying to program it...

by adafruit on Sat May 15, 2010 1:35 am

power the clock, remove the jumper from the usbtiny

adafruit
 
Posts: 12151
Joined: Thu Apr 06, 2006 4:21 pm
Location: nyc

Please be positive and constructive with your questions and comments.