Ice Tube: Blinking Display
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 2
- Joined: Tue Jan 04, 2011 1:45 am
Ice Tube: Blinking Display
Just assembled the clock last night. It was working fine, but when i woke up, I noticed that the display was blinking. I went to reset by power cycling and noticed that I have to wiggle the cord and get it in the right position for the clock to power on. Bad power supply? And would that be the cause of the blinking as well?
- stinkbutt
- Posts: 593
- Joined: Wed Feb 17, 2010 2:40 am
Re: Ice Tube: Blinking Display
Sounds like a bad joint on the board where the DC jack is connected. This bit right here:
-
- Posts: 2
- Joined: Tue Jan 04, 2011 1:45 am
Re: Ice Tube: Blinking Display
Sounds like a good place to start. Thanks
Please be positive and constructive with your questions and comments.