Info on 1212 needed

Chat about pick and place machines, reflow ovens, assembly techniques and other SMT tips & trix

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
robert_flex
 
Posts: 1
Joined: Tue Aug 02, 2016 9:40 am

Info on 1212 needed

Post by robert_flex »

Concerning the 1212 adapter board: What is the pin spacing of the MSOP/TSSOP side of the adaptor? Is there a datasheet for this adapter showing the overall dimensions?

Thanks,

Robert

User avatar
adafruit_support_mike
 
Posts: 67454
Joined: Thu Feb 11, 2010 2:51 pm

Re: Info on 1212 needed

Post by adafruit_support_mike »

The pin spacing for all TSSOP/MSOP packages is 0.025" (40 pins per inch), or 0.635mm.

There's no single datasheet that lists all chip footprints (at least not one that doesn't cost a few hundred dollars from the standards organizations), but any chip in a TSSOP/MSOP package should have a measured drawing toward the end.

In a pinch, ON Semiconductor and NXP have good dimensional information in their datasheets. TI provides good drawings, but they make up their own package names, and it takes about fifteen minutes of reading cross-references to find out if you have the right one.

I think the library used to make the breakouts is part of the Adafruit Eagle library, but here's a copy in case it isn't:
breakouts.lbr.zip
(25.08 KiB) Downloaded 89 times

Locked
Please be positive and constructive with your questions and comments.

Return to “SMT (Surface Mount Tech)”