QFN-32 5x5 breakout (product 1163)
Hi, I just soldered an STM32F051xx to the QFN-32 5x5 breakout. This chip is the "UFQFPN32" package.
Imagine my surprise when I went to connect Vss / GND and found that the breakout has no connection to the center exposed pad. Any suggestions on how to connect to this? My best idea right now is to drill through the center of the breakout before soldering the chip.
For the next revision of this product it would be helpful if the center exposed pad were routed to a breakout pin.