๐Ÿ“ฃ๐Ÿ“ช ๐Ÿšš Adafruit will not be shipping USPS orders Monday January 20, 2020 ๐Ÿ—“. Expedited USPS orders placed after 11am ET ๐Ÿ•š Friday January 17 will go out Tuesday January 21 ๐Ÿ“ฃ๐Ÿ“ช๐Ÿšš
0

connectors
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

connectors

by haldcohen on Thu Jun 29, 2017 1:18 pm

What is the female connector that will fit on the "wire spikes" on the ramps board? I need to attach the bare wires of the stepper motor to the board. Is it the JST connector?

haldcohen
 
Posts: 2
Joined: Thu Jun 29, 2017 1:11 pm

Re: connectors

by adafruit_support_mike on Thu Jun 29, 2017 11:03 pm

Could you post a link to the product you're thinking about please?

adafruit_support_mike
 
Posts: 60259
Joined: Thu Feb 11, 2010 2:51 pm

Re: connectors

by haldcohen on Fri Jun 30, 2017 1:13 pm

RAMPS 1.4 REPRAP 3D PRINTER CONTROLLER

haldcohen
 
Posts: 2
Joined: Thu Jun 29, 2017 1:11 pm

Re: connectors

by adafruit_support_mike on Fri Jun 30, 2017 11:39 pm

I don't think we carry that one, but from what I see in the photos on this page:

http://reprap.org/wiki/RAMPS_1.4

Most of the connectors are either male or female pin header. If you're looking for a connector to work with the male pin header, we have these:

https://www.adafruit.com/category/306

The general term for them is '0.1"/2.54mm rectangular wire connector'.

adafruit_support_mike
 
Posts: 60259
Joined: Thu Feb 11, 2010 2:51 pm

Please be positive and constructive with your questions and comments.